| 1480nm AR-coating SM Fiber Patchcord | |||||||||||
|
The 1480nm SM AR-coating Fiber Patchcord is special designed for lower the light back reflection from free space coupled to fiber or fiber to free space. The fiber patchcord termination connector could be FC, SMA connector or customized. Usually, the fiber patchcord will have one end AR-coated, and the AR-coated end will be well marked. |
|||||||||||
|
|||||||||||
|
Application: |
Features: |
|
|||||||||
|
Optical Signal Transmission Fiber Optic Sensor Laser System Testing System |
Low Reflectivity High Return Loss Low Insertion Loss High Reliability |
||||||||||
| Specification: | |||||||||||
| Parameter | Symbol | Value | Unit | ||||||||
| Center Wavelength | λ | 1480 | nm | ||||||||
| Max. Insertion Loss | IL | 0.5 | dB | ||||||||
| Max. Average AR-Coating Reflectivity | Ravg | 0.5 | % | ||||||||
| Max. Durability | 0.3 | dB | |||||||||
| Min. Plug Times (No AR-coated end) | 1000 | - | |||||||||
| Fiber Type | SMF-28e fiber | - | |||||||||
| Tensil Load | 5 | N | |||||||||
| Max. Optical Power | P | 300 | mW | ||||||||
| Operating Temperature | T | -40~75 | ℃ | ||||||||
| Storage Temperature | T | -40~85 | ℃ | ||||||||
| Notice: Above specifications are tested at center wavelength in room temperature @23℃. | |||||||||||
| Specifications may change without notice. | |||||||||||
| Drawing: | |||||||||||
|
|||||||||||
| Ordering Information (Part Number): | |||||||||||
| ARSMFP-WWWW-FF-J-LL-CC-CC | |||||||||||
| WWWW | FF | J | LL | CC | CC | ||||||
| Wavelength | Fiber Type | Fiber Jacket | Fiber Length | Connector 1 |
AR-coated Connector 2 |
||||||
| 1310 - 1310nm | S2 - SMF-28e fiber | 9 - 900um Loose Tube | 05 - 0.5m | NE - None | FA - FC/APC | ||||||
| 1480 - 1480nm | 2 - 2.0mm Loose Tube | 10 - 1.0m | FA - FC/APC | FU - FC/UPC | |||||||
| 1550 - 1550nm | 3 - 3.0mm Loose Tube | 15 - 1.5m | FU - FC/UPC | S9 - SMA905 | |||||||
| 20 - 2.0m | S9 - SMA905 | SS - Specify | |||||||||
| SS - Specify | |||||||||||
| Notification: | |||||||||||
|
1. AR-Coated end is only for free space application, it will easily damaged if mated or contacted with the other connector end. 2. If the AR-coated connector end surface is not clean, do not use a dry wipe to clean up, try it with compressed air is suggested. 3. Do not mate the two AR-coating end connector, it will increase the back reflections. |
|||||||||||
